Tuesday, 25 October 2016

Installing armbian

 

Now - over a year later - I think it is time for a "relaunch".  I will give armbian a try.

Installation

Before you can install armbian on the board you have to download it from http://www.armbian.com/. At the moment one can choose between an older legacy kernel and an newer vanilla kernel. I took the newer vanilla kernel because I have no need for video acceleration. I want to use my R1 as home server.  When the download is finished you can extract the image of the archive:
7z e archive.7z
Now you have an IMG file. In the next step write the IMG file to the sd card.
dd if=archive.img of=/dev/sdx # replace x by your device number
 After dd stops, sync the file buffers.
sync
Now remove the sd card from your sd card reader and insert it into your R1. Turn it on. If you've done everything right, armbian boots. At the end of the boot process the login prompt is displayed. Log on as root and follow the instruction - you have to change the root password and add a user.

Network

Now you're logged in as root and your network is configured via DHCP.  The default configuration prevents network connections between the ports of the switch. I want my R1 to behave like a simple switch. Fortunately the armbian developers already prepared a network configuration file for this purpose. In /etc/network there is a file interfaces.r1switch. It is the base for my configuration. I copied this file to /etc/network/interfaces an added a static IP address.

auto lo
iface lo inet loopback

auto eth0.101
iface eth0.101 inet manual
    pre-up swconfig dev eth0 set reset 1
    pre-up swconfig dev eth0 set enable_vlan 1
    pre-up swconfig dev eth0 vlan 101 set ports '0 1 2 3 4 8t'
    pre-up swconfig dev eth0 set apply 1

auto wlan0
iface wlan0 inet manual

auto br0
iface br0 inet static
bridge_ports eth0.101 wlan0
  address 192.168.178.2
  netmask 255.255.255.0
  gateway 192.168.178.1
  dns-nameservers 192.168.178.1
At his point I discovered a problem with the swconfig tool. The problem and solution are discussed here. After I installed swconfig from the forum thread everything worked fine.

Update

Now that we have a network connection it is time to update the os.
apt-get update
apt-get upgrade

SATA Disk 

Hint:
When I installed my SATA drive I was hit by one of the shortcoming of this board. Every time I tried to format the disk the board crashed. First I thought the board is defect but then I found out it was the insufficient power supply of this board. I disconnected the USB keyboard and everything worked fine.

To find out the device name list all block devices:
lsblk
Output looks like this:
NAME        MAJ:MIN RM   SIZE RO TYPE MOUNTPOINT
sda           8:0    0 931.5G  0 disk
└─sda1        8:1    0 931.5G  0 part /mnt/data
mmcblk0     179:0    0  28.8G  0 disk
└─mmcblk0p1 179:1    0  28.5G  0 part /
Then format the disk:
mkfs.ext4 /dev/sda1
 Now mount the disk:
mkdir /mnt/data
mount /dev/sda1 /mnt/data
 Add an entry to fstab to make the mount persistent:
/dev/sda1       /mnt/data   ext4   defaults 0 0


No comments:

Post a Comment